mouse trap vehicle kits

A mouse trap vehicle designed for success
Designed by our master mouse trap vehicle builder Bartley Jones, The Torque Master system is the same system used on the Jones Pulley Racer but this car has been tuned up for maximum performance. The Torque Master is engineered to give a mouse trap racer as much as 100% more power... and... keep that power pulling up to 50% longer than all other vehicles! The Torque Master is designed to maximize the winding of the mousetrap's spring more then the traditional 180 degrees. The Jones Pulley system will give your vehicle an almost unfair advantage as the explosive acceleration of this racer causes it to pop a wheelie as it "rockets" off the start line.  The Torque Master is designed for all speed contest and king of the hill climbing challenges.





100% More Power for an Explosive Acceleration
By far, the two biggest secrets to this little mouse trap vehicle's success is the design of its ultra sticky foam wheels and the use of the Jones Pulley System. The ultra sticky foam wheels are essential for providing maximum traction and keeping the Torque Master from spinning out at the start line. The Torque Master is design to allow the mousetrap to wind more than the traditional 180 degrees causing double the traditional potential energy of all other mousetrap racers.

Includes the following: bass wood, ultra sticky foam wheels, Jones Pulley, brass axle and pulley tubing, front light-weight wheels and axle, Victor mouse trap, thrust bearings, kevlar string, and step-by-step plans secret performance tips.

Tools needed: glue, needle-nose-pliers, drill or drill press, scroll saw or hand saw.

Important Notice: The Torque Master is an advanced kit that does not come pre-cut or pre-drilled. The Jones system requires the alteration of the mousetrap spring to wind more than 180 degrees.